Now, we're not going to do just "normal" chins here...we're taking it to the next level for maximum development.
You're going to be doing what's called a "mechanical drop set" of chins, targeting your biceps...and it will set your bicep growth on FIRE by pushing the muscles to the limit.
The key to this technique (for our purposes with the biceps, at least) is to start in a relatively "weak" (but highly focused) movement pattern for the target muscle, progressing to "stronger" (but less focused on biceps) variations of the movement pattern as you fatigue.
For biceps, we'll be starting with a vertical-body chin-up (which puts more focus on the biceps due to increased elbow flexion), followed by a "lean back" chin-up (which is a bit stronger because it shifts more focus to the lats, with a little less on the biceps), finishing with an Inverted Row.
It sounds counter-intuitive to actually want to put LESS focus on the biceps as you fatigue, however it's actually necessary. The biceps are a small muscle, so we're progressively using larger muscles with better leverage to take over more of the movement to push the biceps harder.
And to top it all off, you're not allowed to let go of the bar through the whole tri-set.
Obviously, you will need to be strong enough to do a decent amount of chin-ups to use this technique on a bodyweight exercise, however it CAN be done using a pulldown machine as well, following the same pattern of body position changes (vertical to leaning back a bit, to horizontal).
Part 1 - Vertical Body Chin-Ups For Biceps
This is exactly what the name implies...a chin-up done keeping your toros in a vertical position (and face close to the bar) in order to increase the focus on the biceps.
When performing this part, don't let the elbows straighten to full extension...keep some bend so you keep tension in the biceps at the bottom.
Focus on contracting the biceps during the pull.
When you start to lose form, switch immediately to the next variation (without letting go of the bar).
Part 2 - Lean-Back Chin-Ups for Biceps
Go to full extension at the bottom and as you come up, lean your upper body back so that you're engaging the lats more in the exercise.
Don't focus on the biceps for this one...try to pull more with the lats. The biceps will still be involved, howeve the change in mental focus will allow you to get more reps.
Part 3 - Inverted Rows for Biceps
Ideally, you want to do this drop-set on a rack where you can just set your feet up on the cross-beam and continue non-stop.
Your upper body is horizontal...then just pull/row yourself up towards the bar. This position takes up some of your bodyweight while also putting the biceps in a position of better leverage (and shorter range of motion).
Get as many reps you can of this last exercise until you can't get any more with good form then you're done.
With this technique, you're accomplishing three things for maximizing bicep growth...
1. You're reducing direct loading on the biceps while increasing workload on stronger muscles to push the biceps harder, which allows you to keep going.
2. You're reducing range of motion on the biceps, improving leverage which allows you to keep going.
3. You're using 1 and 2 to increase overall workload on the biceps, which stimulates growth and strength.
This combination will push your biceps HARD! After completing a round, take 90 seconds rest then repeat for 2-3 total rounds.
---
Want to build muscle without trashing your body with non-stop high-intensity workouts? Time-Volume Training can "sneak" up to 5 lbs of muscle on you in just a few weeks with a unique, volume-based approach.
Share This Page...
Want More Mass-Building Techniques and Programs?
You'll find them here...
- Time-Volume Training - Build Muscle and Strength Like Clockwork
- Muscle Explosion - 28 Days to Maximum Mass
- Metamorphosis - Rebuild Your Body From The Inside Out
Support